Equinox AWD V6-3.4L (2008)
Connector Position Assurance Locks
Connector Position Assurance Locks
The connector position assurance (CPA) is a small plastic insert that fits through the locking tabs of the connector. CPAs are used in various connectors
throughout the vehicle. CPAs are also used in all SIR system electrical connectors. The CPA ensures that the connector halves cannot vibrate apart. You
must have the CPA in place in order to ensure good contact between the mating terminals, of the connector.
Connector Repairs
Connector Repairs
Connector Repairs contains a list of all connector repairs. The connector repairs are listed by the connector manufacturer and then by connector type. If
the technician cannot identify the manufacturer of the connector, refer to Identifying Connectors below. Knowing the connector manufacturer will assist
in finding the correct connector repair from the following list:
*
Connector Position Assurance Locks
*
Terminal Position Assurance Locks
*
Bosch Connectors (BSK) Bosch Connectors (0.64) Bosch Connectors (2.8 JPT) Bosch Connectors (ECM)
*
Delphi Connectors (Weather Pack) Delphi Connectors (Push To Seat) Delphi Connectors (Pull To Seat) Delphi Connectors (Micro-Pack 100W)
Delphi Connectors (Micro.64) Delphi Connectors (12-Way)
*
Tyco/AMP Connectors (CM 42-Way) Tyco/AMP Connectors (Sensor) Tyco/AMP Connectors (0.25 Cap) Tyco/AMP Connectors (43-Way)
Tyco/AMP Connectors (Door Module)
*
Yazaki Connectors (2-Way) Yazaki Connectors (16-Way)
*
Repairing Connector Terminals
Connector Anatomy
1 - Connector Positive Assurance (CPA)
2 - Assist Lever
3 - Wiredress Cover
4 - Seal Strain/Relief
5 - Slide Left Hand
6 - Slide Right Hand
7 - Terminal Positive Assurance (TPA)
8 - Terminal Positive Assurance (TPA)
9 - Connector Seal
10 - Connector Housing
11 - Inner Connector
Identifying Connectors
