Equinox AWD V6-3.4L (2008)
5. Turn the slot in the TCM to align the 2 marks. Do not turn more than 60 degrees.
6. Install the TCM (4) over the manual shaft.
Notice: Refer to Fastener Notice .
7. Install the bolts (3).
Tighten the bolts to 25 N.m (18 lb ft).
8. Connect the electrical connectors (3, 5) to the TCM.
9. Install the manual shaft detent lever. Refer to Automatic Transmission Range Selector Lever Replacement (See: Sensors and Switches -
Transmission and Drivetrain/Sensors and Switches - A/T/Transmission Position Switch/Sensor/Service and Repair/AF33-5 - Automatic Transaxle)
.
10. Install the battery tray. Refer to Battery Tray Replacement .
