Equinox AWD V6-3.4L (2008)
Important: Ignition lock cylinder reads key cut position 1 through 9.
1. Insert the appropriate tumbler (3) according to the key code into the corresponding tumbler ward.
2. The tumblers will not immediately seat into position because the sidebar has been pre-assembled. The tumblers will have to be pushed past the
sidebar with a small flat screwdriver or pocket knife.
3. The tumbler springs (2) should then be inserted into the spring wells in the cylinder (4) where they will sit on top of the tumblers.
4. The seal plate (1) will be installed and crimped.
5. Insert the seal plate locator legs into the receptacle slots in the cylinder-seal plate will seat into position only when the two locator legs have been
properly inserted into the receptacles on the cylinder.
