Equinox AWD V6-3.4L (2008)
pump.
7. Remove the power steering reservoir outlet hose.
Installation Procedure
1. Position the power steering reservoir outlet hose to the vehicle.
2. Compress the power steering reservoir outlet hose clamp (1) and connect the power steering reservoir outlet hose (2) to the power steering pump.
3. Compress the power steering reservoir outlet hose clamp (1) and connect the power steering reservoir outlet hose (2) to the remote power steering
fluid reservoir.
4. Clean any excess power steering fluid from the vehicle and remove the drain pans.
5. Install the right side engine splash shield. Refer to Engine Splash Shield Replacement .
6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
7. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering Bleeding/Service and Repair) .