Equinox AWD V6-3.4L (2008)
Power Steering Pump: Service and Repair
Power Steering Pump Replacement
Power Steering Pump Replacement
Removal Procedure
Important: Do not remove the drive belt from the vehicle entirely. Only slip it off the power steering pump and set it aside in the engine
compartment.
1. Remove the drive belt. Refer to Drive Belt Replacement .
2. Remove as much power steering fluid from the remote power steering fluid reservoir as possible.
3. Remove the right side engine splash shield. Refer to Engine Splash Shield Replacement .
4. Place drain pans under the vehicle as needed.
5. Compress the power steering reservoir outlet hose clamp (1) and disconnect the power steering reservoir outlet hose (2) from the power steering
pump.