Equinox AWD V6-3.4L (2008)
Special Tools
J 24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
Notice: Secure the steering wheel utilizing a strap to prevent rotation. Locking of the steering column will prevent damage and a possible
malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:
*
The steering column
*
The intermediate shaft
*
The steering gear
After disconnecting these components, do not move the front tires and wheels. Failure to follow these procedures may cause improper alignment
of some components during installation and result in possible damage to the SIR coil.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the front tires. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
3. Remove both outer tie rod to steering knuckle nuts. Discard the nuts.
Notice: Do not free the ball stud by using a pickle fork or a wedge-type tool. Damage to the seal or bushing may result.
