Equinox AWD V6-3.4L (2008)
6. Remove and discard the lower ball joint cotter pin.
7. Loosen the ball stud nut, until level with the top of the ball stud.
8. Using the J-42188-B , separate the lower ball joint from the steering knuckle.
9. Remove the lower ball joint nut and separate from the knuckle.
Notice: Do not free the ball stud by using a pickle fork or a wedge-type tool. Damage to the seal or bushing may result.
10. Remove the outer tie rod end from the knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement (See: Steering/Tie Rod/Tie Rod
End/Service and Repair) .
