Equinox AWD V6-3.4L (2008)
failure will result. Refer to Sealers, Adhesives, and Lubricants (See: Specifications/Fluid Type Specifications) .
5. Add approximately 3.1 L (3.3 Qt) of GM T-IV fluid to the transaxle , using the fluid level indicator location.
Important: If the check is necessary at a low oil temperature of 30-40°C (86-104°F), perform check using the COLD range on the level
gage. However, the fluid must be re-checked at the proper fluid temperature.
6. Start engine and operate vehicle until transaxle fluid temperature reaches 60-70°C (140-158°F).
7. Apply parking brake.
8. Depress brake pedal and move shift lever slowly through all gear ranges from park (P) to low (L), pausing for about 3 seconds in each range.
Return shift lever to park (P) range at idle condition.
9. Pull level gauge out again and check if fluid level is within the HOT range.
10. If fluid is not within the correct level, adjust accordingly:
1. If fluid is below the HOT range, add enough to bring it up to the correct level.
2. If fluid is above HOT range, drain excess fluid.
11. Install the fluid level indicator. Refer to Transmission Fluid Level Indicator Replacement (See: Automatic Transmission Dipstick - Dipstick
Tube/Service and Repair) .
