Equinox AWD V6-3.4L (2008)
3. Remove the oil cooler fitting from the radiator.
Installation Procedure
1. Inspect the new O-ring seals for cracks, cuts or damage. Replace if necessary.
Notice: Refer to Fastener Notice .
Important: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.
2. Install the oil cooler fitting to the radiator.
Tighten the fittings to 38 N.m (28 lb ft).
3. Install the transaxle oil cooler hoses to the oil cooler fittings on the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting
Disconnection and Connection (See: ) .
4. Fill the cooling system. Refer to Cooling System Draining and Filling (LNJ Static Fill) Cooling System Draining and Filling (LNJ GE 47716 Fill)
Cooling System Draining and Filling (LY7 Static Fill) Cooling System Draining and Filling (LY7 GE 47716 Fill) .
5. Adjust the transmission fluid level. Refer to Sealers, Adhesives, and Lubricants (See: Specifications/Fluid Type Specifications) and Transmission
Fluid Check (See: Testing and Inspection/Component Tests and General Diagnostics/AF33-5 - Automatic Transaxle/Transmission Fluid Check) .
6. Inspect for fluid leaks.
Oil Cooler Hose/Pipe Replacement
Oil Cooler Hose/Pipe Replacement
Removal Procedure
Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist,
provide additional support for the vehicle on the opposite end from which the components are being removed.
1. Position the vehicle on a hoist and raise the hood.
2. Place a drain pan or suitable container under the vehicle.
