Equinox AWD V6-3.4L (2008)
1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to the new output speed sensor O-ring.
2. Install the new output speed sensor O-ring onto the output speed sensor (2).
3. Install the output speed sensor into the transmission case assembly.
Notice: Refer to Fastener Notice .
4. Install the output speed sensor bolt.
Tighten the bolt to 6 N.m (53 lb in).
5. Connect the electrical connector (2) to the output shaft speed sensor.
6. Install the battery tray. Refer to Battery Tray Replacement .