Equinox AWD V6-3.4L VIN F (2006)
Brake Proportioning/Combination Valve: Service and Repair
Proportioning Valve Replacement
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
Removal Procedure
1. Without disconnecting the electrical connectors, remove the transmission control module (TCM) with the bracket from the bracket on the strut
tower and position aside on top of the engine.
2. Place a shop towel under the proportioning valve assembly to catch any brake fluid loss.
3. Important: Prior to disconnecting the brake pipes from the proportioning valve assembly, note the locations of the brake pipes to the valve
assembly, to aid during installation.
Disconnect the caliper and wheel cylinder brake pipes from the proportioning valve assembly.
4. Cap or plug the brake pipe ends to prevent brake fluid loss and contamination.
5. Disconnect the master cylinder brake pipes from the proportioning valve assembly.
6. Cap or plug the brake pipe ends to prevent brake fluid loss and contamination.
7. If the proportioning valve is to be reused, plug the ports to prevent brake fluid loss and contamination.
