Equinox AWD V6-3.4L VIN F (2006)
Oil Pump Drive Shaft: Service and Repair
Oil Pump Drive Replacement
Removal Procedure
1. Remove the lower intake manifold.
2. Remove the oil pump drive clamp bolt.
3. Remove the oil pump drive clamp.
4. Remove the oil pump drive.
Installation Procedure
1. Apply prelube GM P/N 12345501 (Canadian P/N 992704) or the equivalent to the oil pump drive gear.
2. Apply engine oil to the oil pump drive gear assembly for ease of assembly.
3. Install the oil pump drive gear assembly.
4. Install the oil pump drive gear clamp.
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the oil pump drive gear clamp bolt.
^
Tighten the bolt to 36 Nm (27 ft. lbs.).
6. Install the lower intake manifold.
