Equinox AWD V6-3.4L VIN F (2006)
1. Remove protective cap from compressor end of the compressor hose and the compressor.
2. Install new seal washers to the compressor hose.
3. Install the compressor hose to the compressor.
4. Install the compressor hose nut to the compressor.
Tighten the nut to 22 N.m (16 lb ft).
NOTE: Refer to Fastener Notice.
5. Connect the electrical connector to the pressure transducer.
6. Lower the vehicle.
7. Position the compressor hose in the vehicle.
8. Install a new sealing washer to the evaporator outlet hose.
9. Install the evaporator outlet hose to the compressor hose.
10. Install the evaporator outlet hose nut to the evaporator outlet hose.
