Equinox AWD V6-3.4L VIN F (2006)
5. Connect the chassis fuel hose/pipe (2) to the fuel tank.
6. Lower the vehicle from the hoist.
7. Remove the caps from the fuel pipes.
8. Connect the engine compartment fuel hose/pipe (2) to the chassis fuel hose/pipe (3).
9. Connect the negative battery terminal.
10. Prime the fuel system.
1. Cycle the ignition ON for 5 seconds and then OFF for 10 seconds. Repeat cycling twice.
2. Crank the engine until it starts. The maximum starter motor cranking time is 20 seconds.
3. If the engine does not start, repeat steps.
11. Run the engine and check the system for leaks.
