Equinox AWD V6-3.4L VIN F (2006)
Axle Shaft Assembly: Service and Repair
Intermediate Shaft Replacement - With RPO L61
Intermediate Shaft Replacement (L61)
^
Tools Required
-
J 2619-01 Slide Hammer
-
J 44394 Seal Protector
-
J 44467 Output Shaft Assembly Remover and Installer
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the right tire and wheel assembly.
3. Remove the right front wheel drive shaft.
4. Remove and discard the wheel drive shaft retaining ring.
5. Remove the O-ring seal from the intermediate drive shaft at the bearing retainer.
6. Remove the bearing retainer-to-support bracket mounting bolts.
7. Remove the bearing retainer.
8. Assemble the J 44467 and the J 2619-01 to the intermediate drive shaft retainer ring groove.