Equinox FWD V6-3.0L (2010)
Note:
*
DO NOT use any air tools to remove or install the guide pin bolts. Use hand tools ONLY.
*
Install an open end wrench to hold the caliper guide pin in line with the brake caliper while removing or installing the caliper guide pin bolt.
DO NOT allow the open end wrench to come in contact with the brake caliper. Allowing the open end wrench to come in contact with the
brake caliper will cause a pulsation when the brakes are applied.
3. Hold the brake caliper guide pins stationally and remove the brake caliper guide pin bolts (1).
Caution: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible
brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which
may cause damage to the brake hose and in turn may cause a brake fluid leak.
4. Remove the brake caliper and support with heavy mechanics wire or equivalent.
5. Remove the brake caliper guide pins (1) and seals (2).
Installation Procedure
