Equinox FWD V6-3.0L (2010)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module Replacement
Removal Procedure
Warning: Refer to Brake Fluid Irritant Warning (See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Warning).
Caution: Refer to Brake Fluid Effects on Paint and Electrical Components Caution (See: Service Precautions/Vehicle Damage Warnings).
Caution: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to
observe this precaution could result in damage to the EBCM/EBTCM.
1. Place the ignition switch in the OFF position.
2. Remove the accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement (See: Maintenance/Fuses and Circuit
Breakers/Fuse Block/Service and Repair/Removal and Replacement/Accessory Wiring Junction Block Replacement).
3. Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any dirt or debris.
4. Disconnect the EBCM electrical connector by lifting the locking lever upward.
5. Remove the 4 EBCM bolts (1).
