Equinox FWD V6-3.0L (2010)
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the 4 EBCM bolts (1) and tighten the bolts in a cross pattern to 3 Nm (27 lb in).
4. Install the accessory wiring junction block. Refer to Accessory Wiring Junction Block Replacement (See: Maintenance/Fuses and Circuit
Breakers/Fuse Block/Service and Repair/Removal and Replacement/Accessory Wiring Junction Block Replacement).
5. If installing a new EBCM, program the EBCM. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning).
6. Without starting the engine, place the ignition switch in the ON position.
7. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle).