Equinox FWD V6-3.0L (2010)
4. Place the crankshaft balancer in position on the crankshaft.
5. Thread the EN-41998-B - installer in the crankshaft. Ensure you engage at least 10 threads of the EN-41998-B - installer before pressing the
crankshaft balancer in place.
6. Push the crankshaft balancer into position by tightening the nut on the EN-41998-B - installer until the large washer bottoms out on the crankshaft
end.
7. Remove the EN-41998-B - installer.
Note: Always install a new crankshaft balancer retaining bolt and washer.
8. Install the NEW crankshaft balancer bolt.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
9. Tighten the crankshaft balancer bolt to 100 Nm (74 lb ft) and an additional 150 degrees using the EN-45059 - meter.
