Equinox FWD V6-3.0L (2010)
Valve Cover: Service and Repair
Camshaft Cover Replacement - Right Side
Camshaft Cover Replacement - Right Side (LF1)
Special Tools
EN-46101 - Spark Plug Tube Seal Guide
For equivalent regional tools, refer to Special Tools (See: Tools and Equipment/Special Tools)
Removal Procedure
1. Remove the ignition coils. Refer to Ignition Coil Replacement - Bank 1 (See: Powertrain Management/Ignition System/Ignition Coil/Service and
Repair/Ignition Coil Replacement - Bank 1)
2. Disconnect and remove the engine harness from the camshaft cover.
3. Remove the right camshaft cover bolts.
4. Remove the right camshaft cover from the right cylinder head.
5. Clean the mating surfaces of the cylinder head and the camshaft cover. Refer to Camshaft Cover Cleaning and Inspection (See: Service and
Repair/Overhaul/79. Camshaft Cover Cleaning and Inspection)
