Equinox FWD V6-3.0L (2010)
4. Install the EN-46110 - compressor above the applicable valve spring as shown.
Tighten the EN-46110 - compressor nut (2).
5. Install the valve spring keepers.
6. Remove the EN-46110 - compressor.
7. Disconnect the EN-39313 - adapter from the compressed air source.
8. Remove the EN-39313 - adapter.
9. Install the spark plugs. Refer to Spark Plug Replacement (See: Tune-up and Engine Performance Checks/Spark Plug/Service and Repair).
10. Install the rocker arms. Refer to Valve Rocker Arm Replacement - Left Side (See: Camshaft, Lifters and Push Rods/Rocker Arm
Assembly/Service and Repair/Valve Rocker Arm Replacement - Left Side).
11. Remove the EN-46106 - tool in order to prevent crankshaft rotation.
12. Install the starter motor. Refer to Starter Replacement (LAF) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair
)Starter Replacement (LF1) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair).
