Equinox FWD V6-3.0L (2010)
15. Position the battery box inboard to allow for routing of the liquid line.
16. Route the liquid line above the battery box and the ground lug.
17. Lift the rear portion of the liquid line upward and remove the liquid line from the vehicle.
18. Remove and discard the sealing washer from the liquid line. Refer to Air Conditioning System Seal Replacement (See: Heating and Air
Conditioning/Coupler HVAC/A/C Coupler O-ring/Service and Repair/Air Conditioning System Seal Replacement).
19. Install protective caps to the condenser, the evaporator outlet hose, and the TXV to prevent contamination and desiccant saturation.
Installation Procedure
1. Route the liquid line below the battery box and the ground lug.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Connect the negative battery cable nut to the wheelhouse and tighten to 12 Nm (106 lb in).
