Equinox FWD V6-3.0L (2010)
5. Remove the compressor hose nut (2) from the condenser.
6. Remove the compressor hose (1) from the condenser.
7. Unclip hose from fan shroud.
8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Vehicle Lifting/Service and Repair).
9. Disconnect the electrical connector from the air conditioning refrigerant pressure sensor valve.
10. Remove the compressor hose nut (1) at the compressor.
11. Remove the compressor hose (2) from the compressor.
12. Remove the compressor hose from the vehicle.
13. Remove and discard the sealing washers from the compressor hose. Refer to Air Conditioning System Seal Replacement (See: Heating and Air
Conditioning/Coupler HVAC/A/C Coupler O-ring/Service and Repair/Air Conditioning System Seal Replacement).
Installation Procedure