Equinox FWD V6-3.0L (2010)
Transmission Position Switch/Sensor: Service and Repair
6T30/6T40/6T45 - Automatic Transmission
Manual Shift Detent Lever with Shaft Position Switch Assembly Replacement
Special Tools
*
DT-48550 Detent Lever Pin Remover
*
J 41229 Manual Shaft Pin Installer
Removal Procedure
1. Remove the control valve body. Refer to Control Valve Body Replacement (See: Transmission and Drivetrain/Automatic
Transmission/Transaxle/Valve Body/Service and Repair/6T30/6T40/6T45 - Automatic Transmission/Control Valve Body Replacement).
2. Remove the manual shaft detent lever hub pin (1) using DT-48550.
3. Remove the manual shift shaft pin (5). Discard the pin.
4. Remove the manual shaft (2).
Note: Disconnect the actuator rod (3) from the detent lever assembly. Do not remove the actuator rod from the transmission case.
5. Remove the manual shaft detent (w/shift position switch) lever assembly (4).
Installation Procedure