Equinox FWD V6-3.0L (2010)
12. Wrap anti-abrasion electrical tape around the two exposed wires on the body harness up to the back of the connector.
Obtain "*Woven Polyester (PET) Electrical Tape" (Special Order PN RZ97156A00) from Kent Automotive. Refer to Parts Information below.
Reinstall the conduit on the seat airbag harness.
13. Attach the connector to the bottom of the seat using clip, P/N 19258316.
14. Reinstall the seat. Refer to Driver or Passenger Seat Replacement procedure in SI.
15. Repeat the above procedure on the other seat.
16. Enable the SIR system. Refer to SIR Disabling and Enabling in SI.
17. Turn the ignition on and use the diagnostic tool to clear the SDM DTCs and verify that the issue has been corrected. If the code is still current,
refer to the appropriate diagnostic procedure found in SI.
*We believe this source and their products to be reliable. There may be additional manufacturers of such products/materials. General Motors does not
endorse, indicate any preference for or assume any responsibility for the products or material from this firm or for any such items that may be available
from other sources.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer