Equinox FWD V6-3.0L (2010)
18. Remove the 4 rear support to body bolts.
19. Remove the rear support assembly from the vehicle.
20. With the aid of an assistant, remove the rear support from the transmission jack and place it on the floor.
Installation Procedure
Caution: Refer to Fastener Caution ().
1. If a new rear support is being installed, a transfer of components is necessary.
*
Upper Control Arms
Tighten the upper control arm to rear support nut and bolt to 160 Nm (118 lb ft).
*
Lower Control Arms
Tighten the lower control arm to rear support nut and bolt to 110 Nm (81 lb ft).
*
Stabilizer bar and insulators
Tighten the stabilizer shaft insulator clamp bolts to 70 Nm (52 lb ft).
Tighten the stabilizer link to stabilizer shaft nut to 57 Nm (42 lb ft).
*
Knuckles - Loosely install the upper and lower control arm to knuckle nuts/bolts. These fasteners will be tightened later in this procedure after
the wheel driveshafts are installed.
2. With the aid of an assistant, position the rear support onto the transmission jack and firmly secure the support to the jack with straps.
3. Position the rear support assembly to the vehicle.
