Equinox FWD V6-3.0L (2010)
*
Discard the filler plate. It is not reusable.
*
Inspect the pressure switch manifold seals for damage or contamination. Replace the control solenoid valve assembly as necessary.
*
Inspect the upper channel plate bolt holes for damage, peening or burnelling. Any damage around the bolt holes near the PCS switch feed holes
could cause leakage around the PCS switch seals. Replace the upper channel plate as necessary.
13. Remove the 8 control valve body bolts (2) M6 x 65.
14. Remove the 2 control valve body bolts (1) M6 x 55.
15. Remove the manual shaft detent assembly (3).
16. Remove the control valve body assembly (4).
17. The control solenoid valve spring can now be fully removed from the lower control valve body assembly.
Note: The clutch fluid passage seal is not reusable.
18. Remove the 1-2-3-4 clutch fluid passage seal (5).
Installation Procedure
