Equinox FWD V6-3.0L (2010)
Note: The clutch fluid passage seal is not reusable.
1. Install a NEW 1-2-3-4 clutch fluid passage seal (3).
Note:
*
Ensure the control solenoid valve spring is attached to the lower control valve body assembly.
*
Align the manual valve (2) to the detent lever assembly while installing the lower control valve body assembly.
2. Install the control valve body assembly (1).
Note: Ensure proper alignment of the detent assembly to the detent lever assembly with position switch while tightening the bolt. The detent
assembly can move and hit the valve body assembly that could cause improper engagement with the detent lever assembly.
3. Install the manual shaft detent assembly (2).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
