Equinox FWD V6-3.4L (2007)
Seat Heater: Scan Tool Testing and Procedures
Heated Seat Module
HVAC Control Module
Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
Base Model Part Number: The scan tool displays the 8 digit hardware part number of the module.
Calibration Part Number: The scan tool displays the 8 digit part number of the calibration incorporated into the module.
Driver Seat Cushion Heat Status: The scan tool displays Inactive/Active. When the heated seat is on, the scan tool will display the status of the heated
seat as Active.
Driver Seat HVC Level: The scan tool displays High/Low. When the driver heated seat switch is pressed once, the scan tool will display High
indicating the high temperature setting. When the switch is pressed a second time, Low will be displayed indicating the low temperature setting.
Driver Seat HVC Mode: The scan tool displays Off/Back & Cushion. When the heated seat is enabled, the scan tool parameter will display the seat
heat mode status as Back & Cushion.
Driver Heated Seat Sw. - CCP: The scan tool displays Inactive/Active. When the driver heated seat switch is pressed, the scan tool will momentarily
display the switch input of the climate control panel as Active.
End Model Part Number: Before the module has been serviced or replaced, the scan tool displays the module production part number. Then, once the
module has been replaced, the scan tool will display the new serviced part number.
Julian Date of Build: The scan tool displays a 3-digit number. This number is the day of the year that the module was built.
Passenger Seat Cushion Heat Status: The scan tool displays Inactive/Active. When the heated seat is on, the scan tool will display the status of the
heated seat as Active.
