Equinox FWD V6-3.4L (2007)
Important: Hold the fan blade to prevent rotation.
2. Using GE-47827 , or a six point socket, turn the fan motor drive plate in the opposite direction of the arrow stamped on the fan blade.
3. Remove and discard the fan blade.
Notice: Failure to tape off all of the entry points to the cooling fan motor will allow debris to enter and damage the motor.
Important: When reusing the fan motor tape off the front and rear entry points of the fan motor before drilling the rivets.
4. Center punch each of the rivets (1) from the rear of the motor.
5. Drill the head of the rivets (1) from the fan motor using a 6.35 mm (0.25 in) drill bit.
