Equinox FWD V6-3.4L (2007)
Fuel Level Sensor: Service and Repair
Fuel Level Sensor Replacement - Primary
FUEL LEVEL SENSOR REPLACEMENT - PRIMARY
REMOVAL PROCEDURE
1. IMPORTANT: NEW fuel tank module seals are necessary each time the fuel tank module is serviced. Obtain NEW seals for both the
primary and secondary modules prior to beginning this service procedure.
IMPORTANT: There are 2 fuel level sender unit and float assemblies in the fuel tank. There is 1 located on each fuel pump module. The
fuel level sender unit and float is NOT the same for each of the fuel pump modules.
Remove the fuel tank.
2. Remove the fuel pump module.
3. Disconnect the fuel level sender unit and float electrical connector from the underside of the top of the pump module.
4. Release the retaining tabs (1, 2) and remove the level sensor by sliding up.
INSTALLATION PROCEDURE