Equinox FWD V6-3.4L (2007)
1. Install the positive battery cable to the wire loom and re-tape the loom.
2. Install the positive battery cable (4) lead to the starter solenoid.
3. Install the positive battery cable to the engine wiring harness clip (3).
Notice: Refer to Fastener Notice.
4. Install the positive battery cable terminal to starter solenoid nut (6).
Tighten the nut to 10 N.m (89 lb in).
5. Connect the positive and negative battery cable clip (3) to the battery tray support bracket.
6. Install the battery box.
