Equinox FWD V6-3.4L (2007)
3. Position the lower ball joint stud into the steering knuckle.
Notice: Refer to Fastener Notice.
4. Using the SA9140E, install the ball stud nut.
Tighten the nut to 40 N.m (30 lb in).
5. Tighten the strut to steering knuckle bolts and nuts.
Tighten the bolts and nuts to 180 N.m (133 lb ft).
Important: Do not loosen the castle nut for cotter pin installation.
6. Tighten the castle nut enough to allow for cotter pin installation.
Important: The cotter pin must not contact the wheel speed sensor or drive axle.
