Equinox FWD V6-3.4L (2007)
3. Install the nub of the J 41239-1A on the transaxle cooler line seal.
4. Tap the new transaxle cooler line seal into the case bore.
5. Install the transaxle oil cooler line assembly to the transaxle.
Notice: Refer to Fastener Notice.
6. Install the transaxle oil cooler line assembly nut.
Tighten the transaxle cooler line retaining nut to 9 N.m (80 lb in).
7. Lower the vehicle.
Important: DEXRON(R) VI automatic transmission fluid is not compatible with this transaxle. If DEXRON(R) VI ATF is used, transaxle
failure will result. This transaxle uses GM T-IV fluid P/N 88900925.
8. Add fluid to the transaxle. Refer to Transmission Fluid Checking procedure located in this service data. See: Fluid - A/T/Testing and Inspection
9. Start the engine and check for leaks.
