Equinox FWD V6-3.4L (2007)
Control Module: Service and Repair
TRANSMISSION CONTROL MODULE REPLACEMENT
Removal Procedure
1. Remove the battery tray. See: Starting and Charging/Battery/Battery Tray/Service and Repair/Battery Tray Replacement
Important: The transaxle manual shaft must be in neutral (N) position prior to re-installing the transmission control module (TCM).
2. Apply the parking brake and place control shift lever in neutral (N).
3. Remove the manual shaft detent lever (2). See: Automatic Transmission/Transaxle/Sensors and Switches - A/T/Transmission Position
Switch/Sensor/Service and Repair/Transaxle Range Switch Replacement
4. Disconnect the electrical connectors from the TCM.
5. Remove the TCM bolts (3).
6. Remove the TCM (4) by sliding off of the manual shaft.
Installation Procedure
