Equinox FWD V6-3.4L VIN F (2005)
6. Using a flat-bladed tool, gently pry the TPS from the compressor.
INSTALLATION PROCEDURE
1. Measure and cut the new TPS assembly to the proper length.
IMPORTANT: To ensure proper routing and retention, be sure the new TPS assembly is cut to the same length as the original TPS assembly.
2. Remove 9.5 mm (3/8 in) of insulation from the ends of the TPS assembly and the wire harness.
3. Position the stripped ends of wire in the appropriate splice sleeve found in J 44020.
4. Crimp the splices using an approved crimping tool.
5. Gently tug on the wires to ensure proper crimping.
