Express 1/2 Ton Van V6-4.3L VIN W (1999)
INSTALLATION PROCEDURE
1. Install the rear brake hose to the vehicle.
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Connect the rear brake pipes on the rear axle to the brake hose.
^
Tighten the rear brake pipes to the brake hose to 17 Nm (13 ft. lbs.).
3. Install the retaining bolt of the rear brake hose to the rear axle.
4. Install the bracket of the rear brake hose to the rear axle.
5. Install the retaining bolt of the rear brake hose to the rear axle.
^
Tighten the retaining bolt to 17 Nm (13 ft. lbs.).
IMPORTANT: Make sure the brake hose is not twisted. Make sure the brake hose is not in contact with any suspension components.
6. Install the retaining nut and retaining clip to the front brake hose.
