Express 1/2 Ton Van V6-4.3L VIN W (1999)
2. Connect the rear brake pipes on the axle to the brake hose.
^
Tighten the rear brake pipes to the brake hose to 17 Nm (13 ft. lbs.).
3. Install the retaining bolt of the rear brake hose to the rear axle.
^
Tighten the retaining bolt of the rear brake hose to 17 Nm (13 ft. lbs.).
IMPORTANT: Make sure the brake hose is not twisted. Make sure the brake hose is not in contact with any suspension components.
4. Install the retaining nut and retaining clip to the front brake hose.
5. Connect the rear brake pipe to the brake hose.
6. Bleed the brake hydraulic system.
Brake Hose Replacement - Rear (10 1/2 Inch Ring Gear)
REMOVAL PROCEDURE
IMPORTANT: Clean dirt, grease, and other foreign material from the hose fittings on both ends of the brake hose before servicing brake
components.
