Express 1/2 Ton Van V6-4.3L VIN W (1999)
1. Install the brake pipe to the vehicle.
2. Install the brake pipe retaining clips to the frame.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Connect the rear brake pipe and/or the front brake pipe to the Electronic Brake Control Module (EBCM) unit.
^
Tighten the brake pipe to the EBCM unit to 20 Nm (15 ft. lbs.).
4. Connect the brake pipe to the brake master cylinder.
^
Tighten the brake pipe to the master cylinder to 30 Nm (22 ft. lbs.).
5. Bleed the brake hydraulic system.
Brake Pipe Replacement(Front Brake Pipe)
REMOVAL PROCEDURE