Express 1/2 Ton Van V6-4.3L VIN W (1999)
Balance Shaft Bearing: Service and Repair
Removal Procedure
^
Tools Required
-
J 26941 Bushing/Bearing Remover
-
J 38834 Balance Shaft Service Kit
Important: The balance shaft and the front bearing are serviced only as a package. Do not remove the bearing from the balance shaft.
1. Remove the balance shaft.
2. Use the J 38834 and the J 26941 in order to remove the balance shaft rear bearing.
2.1. Install the J 26941 legs behind the balance shaft rear bearing and secure.
2.2. Install the J 38834-1 with the short threaded end through the front of the engine block.
2.3. Install the J 38834-1 into the J 26941.
2.4. Slide the J 38834-2 onto the J 38834-1 and into the balance shaft bore of the engine block.
2.5. Install the bearing, washer and nut on the J 38834-1.
2.6. Hold the J 38834-1 and turn the nut clockwise until the balance shaft rear bearing is removed.
Installation Procedure
^
Tools Required
-
J 38834 Balance Shaft Service Kit
1. Dip the balance shaft rear bearing in clean engine oil before installation.