Express 1/2 Ton Van V6-4.3L VIN W (1999)
7. Remove the engine mount to engine mount frame bracket bolts (right side shown).
8. Remove the engine mount.
9. In order to remove the engine mount engine bracket (right side shown) use the following procedure:
9.1. Remove the engine mount engine bracket bolts.
9.2. Remove the bracket.
9.3. Remove the heat shield, if necessary.
Installation Procedure
1. In order to install the engine mount engine bracket (right side shown) use the following procedure:
Notice: Refer to Fastener Notice in Service Precautions.
1.1. Install the heat shield and bolts.
^ Tighten the heat shield bolts to 6 Nm (53 inch lbs.).
1.2. Install the engine mount engine bracket and bolts.
^ Tighten the engine mount engine bracket bolts to 51 Nm (38 ft. lbs.).