Express 1/2 Ton Van V6-4.3L VIN W (1999)
^
Tighten the cable bracket nuts and bolts to 12 Nm (106 inch lbs.).
7. Install the cruise control cable, if equipped.
8. Install the accelerator control cable to the throttle shaft.
9. Install the EVAP canister purge solenoid valve.
10. Connect the vacuum brake booster hose to the intake manifold.
11. Install the vacuum brake booster hose bracket and nut on the intake manifold stud.
^
Tighten the nut to 11 Nm (97 inch lbs.).
12. Connect the A/C vacuum hose to the intake manifold, if equipped with A/C.
13. Connect the PCV valve hose to the intake manifold and the valve rocker arm cover.
14. Connect the following electrical connectors:
^
The throttle position (TP) sensor
^
The idle air control (IAC) motor
^
The fuel meter body assembly connector
^
The manifold Absolute Pressure (MAP) sensor
^
The EVAP canister purge solenoid valve
