Express 1/2 Ton Van V6-4.3L VIN W (1999)
4. Remove the power steering outlet hose (1) from the steering gear (2).
5. Remove the hose from the vehicle.
INSTALLATION PROCEDURE
NOTICE: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
1. Route the hose in the same position the hose occupied prior to removal.
2. Smoothly route the hose in order to avoid sharp bends and kinking.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the power steering outlet hose (2) to the steering gear (1).
-
Tighten the hose fitting to 27 Nm (20 ft. lbs.).