Express 1/2 Ton Van V8-305 5.0L VIN M SFI (1998)
INSTALLATION PROCEDURE
1. Install a NEW gasket.
2. Install the oil seal housing to the engine block. Refer to Crankshaft Rear Oil Seal and Housing Installation under Engine Unit Repair.
3. Install the following fasteners to the oil seal housing:
^
Three screws using a T27 Torx wrench and one nut.
^
Two lower studs using an E7 Torx wrench.
^
Tighten the crankshaft rear oil seal housing screws and nut to 12 Nm (106 inch lbs.).
^
Tighten the lower studs to 6 Nm (53 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
