Express 1/2 Ton Van V8-305 5.0L VIN M SFI (1998)
7. Remove the four T-25 Torx bolts (1) that fasten the EBCM to the BPMV. Remove the EBCM (2) from the BPMV (4). Removal may require a
light amount of force.
8. Clean the BPMV with a clean, dry cloth.
INSTALLATION PROCEDURE
IMPORTANT:
^
If the EBCM mounting bolts are corroded or damaged, do not reuse the old mounting bolts. Install new EBCM mounting bolts with the new
EBCM.
^
Do not use RTV or any other type of sealant on the EBCM Gasket or mating surfaces.
1. Install EBCM (2) to BPMV (4).
2. Install the four EBCM bolts (1).
^
Tighten the four bolts to 5 Nm (39 inch lbs.) in an X-pattern.
NOTICE: Refer to Fastener Notice in Service Precautions.
3. Connect the four electrical connectors to the EBCM.
4. Install the EHCU Shield.
^
Tighten the three bolts to 12 Nm (8 ft. lbs.).
5. Lower the vehicle
6. Connect the negative battery cable.
7. Revise the tire calibration using the Scan Tool.
8. Return to Diagnostic System Check. Refer to Diagnostic System Check.
