Starter Motor Replacement Guide for Express 1/2 Ton Van V8-305 50L VIN M SFI (1998)
NOTICE: Refer to Fastener Notice in Cautions and Notices.
6. Assemble the through-bolts in their original locations
Tighten
Tighten the bolts to 8.5 N.m (75 lb in).
7. Assemble the motor field lead over the motor terminal on the solenoid.
8. Assemble the field lead attaching nut.
Tighten
Tighten the nut to 11 N.m (95 lb in).
9. Assemble the solenoid shield onto the protruding ends of the solenoid attachment screws.
10. Assemble the shield attaching nuts.
Tighten
Tighten the shield attaching nuts to 8 N.m (70 lb in).
Starter Motor Overhaul (28-MT Driveshaft and Clutch As)
Drive Shaft And Clutch Group
If disassembled, position the driveshaft on a work surface with the internal gear end down. Assemble the driveshaft and clutch group in the following
way:
IMPORTANT: If the center support bearing is being replaced, install it on the driveshaft.
1. Install the driveshaft support to the driveshaft, seating the bearing in the support.
2. Install the clutch drive assembly to the driveshaft.
