Express 1/2 Ton Van V8-305 5.0L VIN M SFI (1998)
6. Remove the seals from the cover, the housing, and the pistons.
IMPORTANT: Check the case servo bore for damage and sharp edges.
7. Clean all the parts using solvent.
8. Air dry all the parts.
9. Inspect the pistons for porosity and damage.
10. Inspect the seal grooves for damage.
11. Inspect the cover for porosity and damage.
12. Inspect for nicks, cuts, and binding in the seal grooves. If damage is found, check for the cause of the damage.
13. Inspect the springs for kinks and bending.
14. Inspect the pin for wear and burrs.
^
Tools Required
-
J33037 Band Apply Pin Tool
1. Install the band apply pin and the J33037.
2. Install the servo cover retaining ring to secure the tool.
