Express 1/2 Ton Van V8-305 5.0L VIN M SFI (1998)
NOTICE: Do not hammer the pinion flange onto the pinion shaft or component damage will occur.
5. Place the washer and the pinion nut on the pinion threads.
6. Tighten the pinion nut to the position indicated by the alignment mark (1) made during disassembly.
7. Measure the rotating torque of the pinion.
^
Tighten the pinion nut to the required torque.
NOTICE: Refer to Fastener Notice in Service Precautions.
8. Fill the rear axle with fluid.
9. Install the propeller shaft to the pinion flange.
10. Remove the safety stands.
11. Lower the vehicle.
