Express 1500 AWD V8-5.3L (2008)
7. Locate the position of the recliner mechanism rod (6) through the cushion cover.
8. Make a small "X" cut just large enough for the recliner rod (6) to go through.
9. Slip the cover over the recliner mechanism rod (6).
10. Install the recliner handle.
11. Position the seat back to the seat cushion assembly.
Notice: Refer to Fastener Notice.
12. Install the bolts (3, 7).
Tighten the bolts to 32 N.m (24 lb ft).
13. Position the seat assembly to the seat adjuster assembly (4).
14. Install the bolts to secure the seat assembly to the adjuster (4).
Tighten the bolts to 25 N.m (18 lb ft).
15. Install the seat into the vehicle.
Caution: To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim.
Failure to do so may cause the system to malfunction.
16. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is
removed. Refer to Passenger Presence System Programming and Setup.
