Express 1500 AWD V8-5.3L (2008)
7. Connect the outer tie rod to the steering knuckle.
8. Install the outer tie rod retaining nut.
Tighten the retaining nut to 63 N.m (47 lb in).
9. Install the wheel hub and bearing. Refer to Front Wheel Hub, Bearing, and Seal Replacement (RWD) (See: Wheel Hub/Service and Repair)Front
Wheel Hub, Bearing, and Seal Replacement (4WD) (See: Wheel Hub/Service and Repair) .
10. Install the wheel drive shaft. Refer to Wheel Drive Shaft Replacement (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle
Shaft Assembly/Service and Repair) .
11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
12. Load the torsion bars. Refer to Torsion Bar and Support Assembly Replacement (See: Torsion Bar/Service and Repair) .
13. Lower the vehicle .
14. Align the vehicle. Refer to Wheel Alignment Measurement (See: Alignment/Service and Repair/Wheel Alignment Measurement) .
